Skip to main content
Skip table of contents

Power Off Hub

You may need to power off the Hub if it is no longer in use.

Do not power off the Hub unless instructed to do so by Checkit.

Hubs no longer in use should be returned to Checkit. Please contact us.

Button I is only accessible using a pen or pencil.

  1. Remove all cables from the Hub.

  2. Hold down buttons I and II on the bottom of the Hub for approximately 10 seconds. The LEDs will go off and then appear all green.

  3. When the LEDs appear green, release the buttons.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.