Repeater LEDs
Repeaters have 3 LEDs that indicate their status: Alert LED, Health LED, Mode LED.
The Health and Mode LEDs do not illuminate unless you press a magnetic tag (see image 1) on bottom left-corner of the device for 3 seconds.
Caution: The Magnetic Tag may interfere with pacemakers and implantable cardioverter-defibrillators (ICDs). Keep the tag at a safe distance from such devices
Image 1: A magnetic tag
See image 2 to locate the LEDs and tag press position on the Repeater.
See the tables below to interpret the LEDs.
Image 2: A Repeater
Alert LED  | |
|---|---|
No LED | There are no alerts on the Hub. |
Blue flashing | There are alerts on the Hub. |
Mode LED  | |
|---|---|
Flashing green → flashing amber | Magnetic tag detected. Remove the magnetic tag and see the Health LED for more information about the Repeater’s status. |
Flashing green → flashing amber → solid red | Device decommissioned Please contact us. |
No LED | If the Mode LED does not illuminate after you press the magnetic tag, the Repeater is powered off. Please connect the Repeater to mains power supply. |
Health LED  | |
|---|---|
Green | Good signal strength |
Amber | Solid amber Moderate signal strength Flashing amber The Repeater is not connected to the Hub. See Install a Repeater. |
Red | Solid red Poor signal strength
1/2 red flashes Low/ critically low battery Reconnect the Repeater to the mains power supply. |
No LED | If the Health LED does not illuminate after you press the magnetic tag, the Repeater is powered off. Please connect the Repeater to mains power supply. |